Home >
blog
> Company Blog About A Must-Read for Cement Product Manufacturers! A Guide to Avoiding Pitfalls When Using Mold Silicone

A Must-Read for Cement Product Manufacturers! A Guide to Avoiding Pitfalls When Using Mold Silicone

2026-11-13

Latest company news about A Must-Read for Cement Product Manufacturers! A Guide to Avoiding Pitfalls When Using Mold Silicone

Silicone molds are widely used in the production of cement landscapes, artistic ornaments, and antique stone. Many people often encounter problems such as molds turning white and brittle, excessive air bubbles, and short lifespan. To ensure the quality of cement products and reduce production costs, it is crucial to master the precautions for using silicone molds.

I. Material Selection

Cement is a strongly alkaline material with inherent efflorescence properties. Ordinary silicone, when in prolonged contact with cement, will harden, whiten, age, and crack after only a few uses, rendering it unusable.

To extend the lifespan of cement molds, it is essential to choose cement mold silicone with high tear resistance, acid and alkali resistance, and low shrinkage. This effectively resists cement alkali corrosion, increases the number of times cement products can be cast, and reduces deformation and breakage of the cement silicone mold.


II. Mixing and Proportioning

The A and B components of the cement mold silicone must be precisely weighed and measured according to the manufacturer's instructions.

Stir in the same direction at a uniform speed, scraping the sides and bottom of the container thoroughly to ensure complete mixing of the two components. After mixing, vacuum degassing is essential; otherwise, residual air inside the silicone will result in air bubbles on the mold surface after curing, leading to a pitted and unusable finished cement product.

III. Release Agent

Before pouring cement, the inner wall of the mold must be coated with an oil-based release agent. Don't skip this step.

Special silicone does not mean completely non-stick; microscopic adhesion can occur at the contact surface in the alkaline environment of cement. Applying a layer of release agent not only isolates it from alkaline corrosion but also completely solves the sticking problem, protecting both the finished product and the mold.


IV. Demolding Timing

The cement must be fully cured before demolding; do not rush it.

Premature demolding occurs before the cement hydration is complete, resulting in a loose internal structure and easy deformation and cracking of the finished product. Simultaneously, the mold is forcibly stretched, leaving permanent scratches and dents, making it increasingly unusable over time.

V. Cleaning and Storage

Post-demolding care is crucial for extending the lifespan of the cement mold silicone. Clean with warm water and a soft-bristled brush. Do not use hard scrapers, steel wool, or strong corrosive cleaners.

After cleaning, air dry in a cool place, then store flat or hanging. Folding and squeezing are strictly prohibited—deformed molds will result in misaligned finished products.

Choose the right silicone, accurately mix the product to fully degas, apply a release agent, patiently wait for curing, gently demold, and finally clean and store properly. Following these five steps correctly will triple the mold's lifespan and produce finished products superior to competitors. For any questions regarding mold making, please leave a message; HANAST silicone can provide targeted answers.