Home >
blog
> Company Blog About Addressing Pumpout Effect in Highperformance GPU Thermal Management

Addressing Pumpout Effect in Highperformance GPU Thermal Management

2026-11-18

Latest company news about Addressing Pumpout Effect in Highperformance GPU Thermal Management

Owners of high-performance graphics cards such as the RTX 4090 are increasingly reporting a gradual widening gap between core temperature and hotspot temperature during sustained heavy workloads. The trend is closely associated with the so-called pump-out effect in thermal paste, a mechanical failure mode that degrades heat transfer over time rather than all at once.

What is the pump-out effect?

Pump-out describes what happens when a graphics card cycles repeatedly through rapid heating and cooling. Because the silicon die and the cooler baseplate expand at different rates, and because mounting pressure causes minute relative movement, thermal paste is steadily squeezed away from the center of the die toward its edges.

The result is a characteristic pattern: a dried, ring-shaped residue at the center of the chip where the paste has been pushed outward, accompanied by a sharp decline in thermal conductivity. On flagship cards running with power limits unlocked to 600W, such as the RTX 4090 TUF, the severity of these temperature swings can accelerate the process considerably.

Comparing common thermal materials

Even high-performance paste can show rising temperatures within a matter of weeks under extreme thermal cycling. The table below compares how common materials perform in high-heat, high-cycle environments.

Material type Characteristics Typical use case
Conventional thermal paste Easy to apply; high initial thermal efficiency Devices with moderate power draw and less frequent thermal cycling
PTM7950 phase-change pad Changes phase when heated; excellent resistance to pump-out High-power GPU and CPU environments with intense thermal cycling

For cards that operate at modest power levels, the convenience of paste remains a practical option. The trade-off emerges only when thermal loads become extreme and repetitive, where the material's ability to stay in place matters as much as its raw conductivity.

Technical analysis and recommendations

For the thermal maintenance of high-power graphics cards, simply swapping in a higher-spec paste tends to address only the short-term symptom. The mass of the cooler assembly and the intensity of the thermal cycles combine to place sustained mechanical stress on whatever material sits between die and cold plate.

Community consensus therefore leans toward PTM7950 phase-change thermal pads for these configurations. The material shifts phase once it reaches a specific temperature, allowing it to flow into microscopic gaps and then hold a stable structure, which in turn suppresses pump-out over long service intervals and keeps the core-to-hotspot delta consistent.

Frequently Asked Questions
How can you tell whether a graphics card is suffering from pump-out?
If the difference between core temperature and hotspot temperature widens noticeably after a period of use, and disassembly reveals dried paste with a ring-shaped residue spreading outward from the center of the die, pump-out can generally be regarded as the cause.
Is the PTM7950 phase-change pad suitable for every graphics card?
PTM7950 is particularly well suited to GPU and CPU environments with high power draw and intense thermal cycling. For cards of ordinary power levels, conventional high-performance paste is usually sufficient, but for high-output models such as the RTX 4090, phase-change material offers an advantage in long-term stability.
What installation details matter when replacing thermal material?
Old paste should be removed thoroughly so the die surface is completely clean. When refitting the cooler, tighten the screws in a diagonal sequence to keep pressure on the baseplate even and prevent localized over-compression that can drive the thermal material away prematurely.