2026-11-18
Condensation-cure, or tin-cure, liquid silicone remains a standard material in mold making, valued for its flow characteristics and reliable release performance in hand-casting and industrial prototype work. Smooth-On's Mold Max and OOMOO lines are among the most widely used product families in this category, serving a broad range of complex mold reproduction applications.
Tin-cure silicones are typically differentiated by cured hardness, viscosity and working time. The Smooth-On range covers multiple hardness levels and flexibility profiles, allowing users to match a material to specific casting conditions and model geometry.
| Series | Representative models |
|---|---|
| Mold Max™ series | 30, 60, 40, 29NV, 14NV, 15T, 20, 10T, XLS™ II |
| OOMOO™ series | 30, 25 |
| Specialty format | PoYo™ Putty |
Before beginning any mold-making project, users should review the product's Technical Bulletin and Safety Data Sheet (SDS) . These documents set out mix ratios, working time and cure conditions, and they remain the primary reference for correct handling.
Because the formulations may contain specific chemical components, packaging commonly carries a California Proposition 65 compliance warning. Operators are advised to work in a well-ventilated area and to wear appropriate personal protective equipment to keep the process safe and compliant.
Material choice generally turns on the intended model substrate, the required surface detail and the expected service life of the mold. Working time and viscosity also shape how easily a compound can be poured and de-aired around complex geometry.
Volume of production and tolerance requirements further influence the decision, since longer production runs place different demands on a mold than one-off prototype work.