Latest company case about Shenzhen Hanast New Material co.,LTD Certifications

HN-8830A/B is an addition-cure (platinum) thermally conductive silicone potting compound with 3.0 W/m·K thermal conductivity, designed for high-power electronics in harsh environments. This B2B case study focuses on its use in new energy vehicle (EV) DC-DC converters, automotive HID lamp power modules and automotive ignition-system modules.

Automotive and EV electronics operate under continuous heat, vibration and thermal cycling. OEMs and Tier-1 suppliers require:

• High thermal conductivity to protect power devices and extend life;
• A wide operating temperature range (−40°C to 200°C) for engine-bay and inverter environments;
• UL94 V-0 flame retardancy for vehicle safety compliance;
• Electrical insulation and protection against moisture and contaminants;
• Fast, repeatable processing for high-volume production lines.

HN-8830A/B combines high heat transfer with rubber elasticity across a broad temperature range, resisting thermal cycling without cracking. Its 1:1 ratio and 30-minute 80°C cure suit automated automotive lines, while UL94 V-0 and ≥1.0*10¹⁴ Ω·cm insulation support safety and reliability goals.

1. Pre-mix Component A and shake Component B thoroughly.
2. Weigh A and B accurately in a 1:1 ratio by weight.
3. Mix until uniform in colour, scraping walls and bottom.
4. Vacuum-degas for void-sensitive modules.
5. Pour into the clean, dry device within the pot life.
6. Cure 4–8 h at room temperature or 30 min at 80°C.

This addition-cure silicone may fail to cure in contact with organotin/tin-containing silicones; sulphur, polysulphides or sulphur-containing articles; amines, polyurethane rubber or ammonia-containing items; phosphorus compounds; organic acids; and solder-flux residues. Substrates and tools must be clean and free of these contaminants. Do not use in contact with condensation-cure (acetoxy) silicone, epoxy resin or polyurethane.

• Efficient 3.0 W/m·K heat transfer improved EV DC-DC converter reliability;
• Thermal stability from −40°C to 200°C handled automotive thermal cycling;
• UL94 V-0 and high volume resistivity supported safety compliance;
• Fast 80°C cure fitted high-volume automotive production;
• Robust encapsulation protected modules against moisture and vibration.

For automotive and EV electronics manufacturers, HN-8830A/B delivers high thermal conductivity (3.0 W/m·K), UL94 V-0 flame retardancy and reliable −40°C to 200°C performance with convenient 1:1 processing. Shenzhen Hanast New Materials supports B2B partners with samples, technical data and application guidance.