This two-component condensation-type room-temperature curing silicone rubber, also known as RTV-2 liquid silicone rubber, is supplied as Component A (base silicone) and Component B (curing agent). Mixed at a 10:1 ratio by weight, it cures through a condensation reaction into a high-performance transparent elastomer with good adhesion, no corrosion, small chemical shrinkage and no exotherm during cure. The cured material offers excellent electrical insulation, waterproof and moisture-proof protection and a wide operating range from −50 °C to 200 °C.
| Property | Condition | Unit | Value |
|---|---|---|---|
| Appearance (A / B) | Visual | — | Transparent liquid / Transparent liquid |
| Viscosity Component A | GB/T 2794-1995 | mPa·s | 2200-2600 |
| Viscosity Component B | GB/T 2794-1995 | mPa·s | 20-30 |
| Density Component A | GB/T 2794-1995 | g/cm³ | 0.94 ± 0.02 |
| Mix Ratio (A:B) | By weight | — | 10:1 |
| Mixed Viscosity | GB/T 2794-1995 | mPa·s | 2200-2600 |
| Full Cure Time | 25 °C | h | 8-24 |
| Dielectric Strength | — | kV/mm | ≥14 |
| Dielectric Constant | — | — | ≤3.0 |
| Elongation at Break | — | % | ≤100 |
| Operating Temperature Range | — | °C | −50 to 200 |
The 10:1 mixed compound must not be heated immediately after mixing; only after initial cure may gentle heating (≤60 °C) be applied. Do not fully seal the potted device or heat above 100 °C before the curing mass is fully released — if complete sealing is required, wait 3 days in summer or 7 days in winter. Small molecules are released during condensation curing, so ensure adequate ventilation and do not seal prematurely.
Data measured at 25 °C and 50-60% RH after the recommended cure schedule and for reference only. Actual performance may vary with application conditions.
Overall Rating
Rating Snapshot
The following is the distribution of all ratingsAll Reviews